Nissan Skyline GT-R (R32 V-Spec, R33, R34) Rear Rotors

Fitment Note: These rotors require the backing plates on the rear pads to be trimmed flush to the pad material. Please contact us if you have any questions or if you would like to buy pre-trimmed pads.

These GiroDisc 2-piece rotors are a direct replacement for the Nissan R32/33/34 Skyline GT-R. Weighing in at 15.8 lbs per rotor, these fully floating assemblies help shed unsprung weight and rotating mass from the rear axle of the vehicle.

The rotor rings are machined from a proprietary casting made of high-carbon iron formulated to GiroDisc’s specifications. This superior metallurgy results in a rotor that holds up better, and the 48 curved vanes act as a centrifugal pump pulling air in through the hub to effectively cool the rotors under hard use. The 2-piece design means a reusable hat which can be attached to new rings (part number D2-357) when they need to be replaced.

All major components including the hats, rotor rings, and drive pins are manufactured in-house at our facility in Bellingham, WA from domestically sourced materials. The hat is made from 6061-T6 aluminum and coated in a black anodize finish. The drive pins are made from a high-strength steel alloy and cadmium-plated for corrosion resistance. All rotors are assembled with spring clips and Belleville washers for race-ready float while also being street-friendly with no noise from loose hardware.

Diameter: 300mm
Thickness: 22mm
Weight: 15.8 lbs per rotor assembly

The minimum thickness at which we recommend replacing these rings is 20mm. We also recommend replacing them if a crack leads to the edge of the ring.