Ford S197 Mustang GT500 ('13-14) Rear Rotors

Please note: these rotor assemblies are only for the 2013-14 5.8L GT500 brake setup with 350mm rear rotors. These GiroDisc rear rotors are upgraded to 22mm thick versus 19mm from the factory, but this upgrade does not require any modifications.

While this 350mm setup can be retrofitted to the rear of other S197 Mustangs, we encourage you to fully research the necessary parts to fit these 350mm rotors to your car.

These GiroDisc 2-piece rotors are a direct replacement for the rear rotors on the 2013-14 S197 GT500 with the 5.8L motor. Our 2-piece, fully floating assemblies help shed unsprung weight and rotating mass from the rear axle of the vehicle.

The rotor rings are machined from a proprietary casting made of high-carbon iron formulated to GiroDisc’s specifications. This superior metallurgy results in a rotor that holds up better, and the 48 curved vanes act as a centrifugal pump pulling air in through the hub to effectively cool the rotors under hard use. The 2-piece design means a reusable hat which can be attached to new rings (part number D2-091) when they need to be replaced.

All major components including the hats, rotor rings, and drive pins are manufactured in-house at our facility in Bellingham, WA from domestically sourced materials. The hat is made from 6061-T6 aluminum and coated in a black anodize finish. The drive pins are made from a high-strength steel alloy and cadmium-plated for corrosion resistance. All rotors are assembled with spring clips and Belleville washers for race-ready float while also being street-friendly with no noise from loose hardware.

The minimum thickness at which we recommend replacing these rings is 20mm. We also recommend replacing them if a crack leads to the edge of the ring.

Sold and priced per pair.